Quote Originally Posted by hxbunny View Post
It says that it is a column shift cut out, looks in good nick compared with what i've seen, not original for Sandman but looks pretty classy anyway
i am one that reads adds..i went back and read it again and yes its there...:Chin:

--- Updated ---

Quote Originally Posted by mook View Post
hmm, tried fitting the halogen globes yesterday..
Not much luck to be honest, found i was missing x2 retainers and the H4 bodys don't fit in the cup. Or whatever it is called. Plus the fit was rubbish. Thankyou Kingswood Country.
The old sealed beams fit so much better. I may go back to them,
Any advice on how to get them in ski man?

Another Problem.

I did not pre fit the taillight surrounds before painting the van, so I'm wondering was there anything in the holes for the pins to sit in? Rubber grommet etc?

The list of missing bits
x2 Headlight Retainers
X2 Drip Molds
X1 GM Indicator body ( i can't remember which side) The aftermarket ones are shocking!

Back to the wreckers for mook.
the bucket for h4 has a bigger hole.you can cut it out or i will have some i would think..on the sinbox i just used a drill bit that was the same size as the pin.
ive also got all the other bits..