Rare Spares cowl drain tubes

[BIGCAV]

Has anyone used RS cowl drain tubes on a HJ? I bought a set and the right hand side is not flared (left one is) to go over the metal drain spout. I tried fitting it but split the rubber tube. They are listed on RS site as fitting HQ - HZ.
Is it a RS stuff up or am I doing something wrong?

just to summarise for anybody else reading and as you are probably already aware these are getting fixed up as we speak and ill send you out another one as soon as they are in

Yet ANOTHER RS part that doesnt fit!!!!!!
None of the wiring harness clips supplied in their kit are for a HJ either

Can you supply photos etc of which clips you have in your bay? iv read it twice now on here plus on fastlane that you mention our kit is wrong and incorrect to the parts catalogue, i have double checked and these clip kits are correct to my parts catalogue's, but like its been mentioned before these catalogues cant always be trusted and id much rather see them from an actual car. I have even tried finding a genuine unmolested hj to check against but they are next to impossible to find, every one has been modified in some way and not original so the parts catalogue is all i have to go off of in regards to those clips

here is the list of clips in the kit and this image was made cropping a few sections of the catalogue out, yes most of the clips are 6 cylinder clips but it is every clip we make to suit hj bays in the set, some are 6 some are 8 some are to suit both etc, im sure they cant ALL be wrong?

HJ.jpg

ill gladly add other clips to the set if need be and if we make them but which clips do you need? i do remember you showing me a 2818034 clip but iv just checked again and cant find this in any HJ catalogue, if someone else can confirm if this was infact in a hj i will add it in, the only other hj i could find didnt have it but it was also half stripped at the time