Ute Spoilers: Original or Aftermarket?

[agr071]

Hey Byron.
In your information you have, what size single exhaust system is it for 308?
I spoke to an exhaust guy, and he reckons that it has twin 1 7/8 engine pipes which goes into 1 5/8 tailpipe.
This sounds WAYYYY to small. He said it's more for torque in a commercial vehicle.
So what can you tell me???

[wbute]

I bet that makes them sound like...... I dont know..... crap?

[HK1837]

My Premier has it's original exhaust and it is 1 7/8" with a step down to a smaller pipe muffler. As far as torque is concerned I reckon he is full of sh!t. I'd bet my left knacker than you dyno my Premier with it's current system and then Dyno it with the 2.5" twin it will be getting and it has much more power and torque than the original.

[agr071]

I want to take the 3" single off and put a single 2 1/2" on.
I was stoked with the single my HG had on it, so i want to do the same again.
It joined into single next to the gearbox and i can't seem to find a new system the same.

[ozbox]

werrent those rear spoilers called bob jane spoilers?...

from my memory bob jane tyres put them on all there delivery utes and thats where they came from..

[wbute]

There is a pic of those Bob Jane utes in the latest Aus Muscle Car mag. They made a good seat for some tidy looking pit girls!

[skid]

Bob Jane did do them for the utes.
held on with three PK screws each side.. and stayed there..

our promo girls use to lean against them while being driven around Lakeside..

would have some old photo's somewhere.