Finally have the Monaro in the new shed and want to wire it up, I have the HQ and HZ wiring diagrams and have identified most of the connectors but still have a few to go.
I have an HZ Statesman loom with GTS dash, A/C, HQ body harness and an efi 5ltr so it is a little more complicated than normal, plus I haven't had the room to even open the doors for 2 1/2years so I have forgotten most of what I had learnt previously
first question as the loom comes through the firewall what do the 2 pink wires hook up to?
also the dk blue/violet and green wire are they for the auto kickdown switch (mines manual)?
edit... there is also an orange wire in from the same spot ??
the heater control switch (brown, yellow and orange wires) goes where, is it surplus to requirements due to the A/C?
thanks in advance
Leroy


 
			


 
			
			 
					
						 
					
						
 
					
					
					
						 Reply With Quote
  Reply With Quote


 
						 
						 so it was about time I got motivated again. I have sourced a VN fuel tank and am in the process of getting the filler neck moved to the back of the tank. Drilled a 2 1/2" hole in the firewall for the computer plug and have a couple more wires to hook up, hoping to have some power through the loom shortly to test everything is working before the front end goes back on.
 so it was about time I got motivated again. I have sourced a VN fuel tank and am in the process of getting the filler neck moved to the back of the tank. Drilled a 2 1/2" hole in the firewall for the computer plug and have a couple more wires to hook up, hoping to have some power through the loom shortly to test everything is working before the front end goes back on.
						
Bookmarks