HZ Van

[ozbox]

mook,ive got all the bits you need....also..the short centre console is mounted by 2 brackets which are both rear console brackets if it was a long one,get my drift?..you a chippy.attach 2 blocks of wood to tunnel via tech screws and then attach console to blocks of wood via wood crews...

--- Updated ---

[/COLOR]Brake bleeding will be easier with two people. One person pumps the brake pedal and then holds it depressed. The other mug gets to undo the bleed screw and let some fluid out then re tighten the bleed screw. Keep doing this until air bubbles stop coming out and new fluid appears. Keep the resovoir topped up. If you dont keep the pressure on the brake pedal until the bleed screw is tightened it will just suck air back into the system. Same goes if you let the resovoir get too low. Push a bit of hose over the bleed screw and catch the old fluid in a jar to save on mess and wash any spilt fluid off with water straight away. Throw the old fluid away.

the problem with this old skool bleeding is it generally screws the seal on the master cylinder because the car and its master are old..ok with a brand new master cyl...if you have a compressor then go and buy a self bleeder which is a pop to use with one person as wb said which i deleted..sorry james...
also when bleeding brakes..start at furthest wheel from the master cyl...which is left rear,then right rear,then left front,then right front..easy as..