The Printing of HX/HZ Sandmans Stripes.

[HZSandman]

I already have my DY3 but these pics still excite me.:knockout::knockout:

[stickthis]

I already have my DY3 but these pics still excite me.:knockout::knockout:

Yes they are pretty! =) Will look even better with the red!

[ozbox]

nice...almost makes me want to stripe my van...can i buy the side stripes without the sandman bits???

[stickthis]

nice...almost makes me want to stripe my van...can i buy the side stripes without the sandman bits???

Yes mate sure can. I have some DY3 HX (lighter red) stripes fully done. (side stripes only). They where part of our first batch.
But yes if you just wanted stripes that's no worries at all. We will always offer these stripes. We are happy even if you just want a door stripe happy to sell just that.

Happy also to do once off colours. But be aware these will be priced much higher than standard colour combos due to the amount of clean up!

Cheers
Jason

[stickthis]

OUCH!!!!!!! This is one thing we did not want to happen!:cry: Last colour of the HX DY3 stripes!

A ripped screen. This is going to slow things down yet again..... Will need to be repaired. Another cost... bugger... Is going to add another couple of weeks. Have a few of the HX DY3 combo done that are ok. (printed before the ripping of the screen)...

Very very sad......

[wbute]

Frustrating! The screens must be made out of light material?

[agr071]

So what causes things like this to happen?

[stickthis]

Frustrating! The screens must be made out of light material?

Yes correct they are! They are under very very high tension also. Also the other issue is a very fine thread material is being used. Which means we get sharper lines.

This is the 3rd time a ripped screen has happened!