Fitting HZ GTS Dash to WB Ute... Help Needed..

[MHT862]

hey mate , good to see you have a proper go of things yourself.
had a read through excellent project well done.

the back of hz combo gauge has a red link wire that goes between the two red 5v pins. (on mine) just pulled it apart a week ago. asume is right, gauges were working before i stripped them. can get you a photo if you need. see if that helps. cheers

[83 WB_Ute]

hey mate , good to see you have a proper go of things yourself.
had a read through excellent project well done.

the back of hz combo gauge has a red link wire that goes between the two red 5v pins. (on mine) just pulled it apart a week ago. asume is right, gauges were working before i stripped them. can get you a photo if you need. see if that helps. cheers

Thanks mate!! Yeah, my HZ gauges have the posts for the red wiring, but no wiring!! lol A photo would be a great help.. also, do you know where the red wires go into?? Into the gauge wiring harness or somewhere else???

Thanks for the help.

[MHT862]

not sure exactlly which red wires you mean. if you mean the red 5v pins then they just have a short wire (4 inch long) with a plug each end going from one 5v pin to the other 5v pin and not connected to anything else. and on my loom theres three other wires, blue, green and tan and they went to the pins with those colours written next to pins. other than that, (i pulled loom out of box) and cant find any other red wires that go to fuel,temp etc gauges. let us know how you get on. im far from an expert but do have dash and loom out at minute and can have a look for you.