G'day mate, welcome to the forums. What do you need - the measurements as to where to put them? I just threw a tape measure on my original guards (not weld-ins) and the measurements were (give or take a couple of mm here and there) on my left guard:

At the top: 60mm in from the back edge of the guard to the indented part of the top flute, and around 40mm from the cheat line (hip) of the guard to the top of the indented area of the top flute.

At the bottom: Seems to be around 55-57mm from the rear edge of the guard to the intented area of the bottom flute.

I didn't measure the right hand guard, but presume it would be similar/same. Hope that was what you were after?

Regards,

Dave