GTS fluted guards

[V6HZute]

hi guys im fairly new to the whole customising and modifying side of the car world and looking to get some help about fluted guards as they are weld ins and no instructions and kind of nee the help as i'm 2 weeks away from painting the old one tonner

[Taily]

G'day mate, welcome to the forums. What do you need - the measurements as to where to put them? I just threw a tape measure on my original guards (not weld-ins) and the measurements were (give or take a couple of mm here and there) on my left guard:

At the top: 60mm in from the back edge of the guard to the indented part of the top flute, and around 40mm from the cheat line (hip) of the guard to the top of the indented area of the top flute.

At the bottom: Seems to be around 55-57mm from the rear edge of the guard to the intented area of the bottom flute.

I didn't measure the right hand guard, but presume it would be similar/same. Hope that was what you were after?

Regards,

Dave

[V6HZute]

cheers dave its exactly what i was looking for

[V6HQUTE]

everytime i look at your name thing i think i didnt write that lol, isnt your tonner a wb??

[V6HZute]

everytime i look at your name thing i think i didnt write that lol, isnt your tonner a wb??

yeah myles with a hz single headlight front

[V6HQUTE]

twin headlight for the win lol

[V6HZute]

twin headlight for the win lol

yeah would love to have a twin headlight front but wont have one until the hq comes up
which i dont mind but atm i need to do this tonner