Front Spoiler cutouts

[L31 Sandman]

Hi, does anyone here have the dimentions or templates to cut out for a front spoiler?

[chrisp]

I dont have the dimensions, but I have an original car, with a missing front spoiler. I could take some measurements.
Unless your putting a genuine spoiler on, I dont think you will need the holes.
Chrisp

[L31 Sandman]

Some measurements and Photos would be great. You never know what may come up. aqua5000@bigpond.com

thanks Heaps.

Scott

[chrisp]

Sorry, I've had a big week.
I'll get the dimensions over the weekend
Chrisp

[hainzy]

When I fitted the front spoiler to mine I just toyed with the spoiler and marked the cut out areas with a texta and slowly cut bits out and made adjustments. Worked fine. Its more fiddly to do it that way but in some ways better as once youve cut bits out its hard to put them back.

[playwme]

Mine starts 10mm down from the hole for the outer bumper bracket and the spoiler hole is 115mm high

Width wise it starts 40mm from the edge of the nose panel (the straight edge that's tucked under the guard) and the spoiler hole is 240mm wide in the middle (+10mm at the top and -10mm at the bottom.

[Indy Orange]

Hi all,i have a HJGTS and am thinking of fitting the front spoiler,and some photos of some original cut outs would be great,even a stencil taken from the side of the bumper bracket to the cut out would provide a starting point. Hoping someone can help cheers Paul.

[adam perth]

i have an original Panama green ( HZ ) front apron with the factory cut outs. i can get stencil off that one.

not sure if the HJ front spoiler was the same as HZ??

[Indy Orange]

Yeah come to think of it Adam not sure myself if they were the same or not i'm thinking they were ,i'm going to buy a Rares one and they suit Hj to Hz ,and do the cutouts with a Dremel with the cutting disk.But that would be a great help if you could do that ,much appreciated.

[L31 Sandman]

stencil would be good along with some pics....please do