Another Adjusting Problem on my WB!!!

[HK1837]

It may also have the wrong throwout bearing, it is common and many experienced people get it wrong. I'd talk to a clutch mob that knows what is going on before you touch it. Get a photo of the throwout bearing carrier and bearing from below and post it up here. Oz knows them back to front.

[83 WB_Ute]

It may also have the wrong throwout bearing, it is common and many experienced people get it wrong. I'd talk to a clutch mob that knows what is going on before you touch it. Get a photo of the throwout bearing carrier and bearing from below and post it up here. Oz knows them back to front.

Went and measured it and it is about 40mm out from what it should be, so it will need to come out and get adjusted.. I think it might have the right throwout bearing, but am not 100% sure because I just put the motor and box in from the parts car.. lol I think I'll just take the whole lot out, adjust the 3spd on my reco'd motor and put that back in.. I'll se how I go with the photo..