Laminex glue or contact adhesive along edges etc is a good way don't put it on thick but coat both surfaces wait untill it is tacky dry .this can pulled of the glue and reglued several times to get everything in the right place and tight
I thick you can thin the glue a little with thinner outer wise as above with q set
I sure we put a line off glue on the bottom edge of the front strip Trimmed the lining later and fold around ready for the front rubber trim later, remember you can carefully pull it of the contact and reglued without adding more glue
In some areas we would of refitted the lining 3 to 4 times
I'am no expert at this job only an assistant
Clamps are also a help to get the initial position
Great advise from q up
Make position of belt holes, light ,mirror and sun vissors
Reply With Quote
Bookmarks