Must admit...I didnt think this build would involve any woodworking skills...but alas!!!
The cab wall facing the tub...i was going to use the same profile as the floor.....but because im a tightarse and dont want to pay $150 for a stamped sheet of metal, (i just think its overpriced in reality) I'll just use flat 1mm sheet but have the sandman logo on there to break it up. Just a bare flat piece of sheetmetal would look crap in my opinion... so i blew up the logo in photoshop, traced onto a bit of 16mm MDF and proceeded to get all fancy!!! It'll give it that embossed kinda look. Then i'll spray over it with chicken shit or whatever tub lining spray product i find. At almost a metre long, that should fill the gap nicely!! I'll cut it out tomorrow....cant feel my hand after all that Dremel use
Almost didnt do it just so i could hang it in the garage!! But once i started, i was pretty much committed
Y'all like it??
Reply With Quote
Bookmarks