Grunt's Papaya HX Sandman 18v 308 4 speed Project

[Vombil]

Similar, im using KBS Rust Seal http://www.kbs-coatings.com.au/kbs-rustseal The guy who makes this is Australian and he developed the POR-15. The RustSeal seems to be good stuff, dont get it on your hands takes forever to get off

ive used kbs on a low intensity residential application and found it to be rubbish. just my opinion. wouldn't use it unless it was on interior side of floor pans or something similar

haven't tried POR15 yet but that will be the next port of call i think

[Grunt]

ive used kbs on a low intensity residential application and found it to be rubbish. just my opinion. wouldn't use it unless it was on interior side of floor pans or something similar

haven't tried POR15 yet but that will be the next port of call i think

Well I will see in a few years at the end of the day it is only a urethane paint, not too may mysteries. It has stuck very well, ive dropped spanners on it etc and not flaking or cracking. Each to their own in the end and time will tell.

Still better im sure than all the scratched flaking factoru paint, dirt and grease that was there before