Grunt's Papaya HX Sandman 18v 308 4 speed Project

[Grunt]

So I have been doing a few cruises and shows and wanted a bit more under bonnet bling. I bought a sheet of 3mm mirror acrylic sheet to make mirror in fills under the bonnet. I had an old bonnet left over so I used that to make the templates.
2x beer boxes later I had a set.
The mirror was cut with a jigsaw. Where the mirror fixes under the bonnet I put that clear body vinyl, the stuff used to stop stone chips in those areas.
The reason for this was if ever the mirror needed to be removed the paint would not be damaged and the whole underside would look factory again.
The mirror was installed using double sided foam tape and urethane adhesive.

Thanks to the many photographers at the shows who can take much better photos than I do