ive come to the first problem/ setback with the build, i have begun putting together the front end, upper control arms stubs and discs all went on no worries. got to the lower control arms grabbed my ball joint pressing tool and found i dont need it, the lower balljoint hole is flogged out on both lower control arms the balljoints just fall into position, such a pain considering they've been sandblasted painted new bushes etc, i think some of the problem may have been that ive had them sandblasted so im sure a few layers of paint were removed but also those tiny ribs may have been worn down a fraction and now its too loose, so now ive got to grab another pair clean them up and i reckon sand them up by hand paint them and have new bushes pressed in, i know i can have the others pressed out and re use them but i would rather just have new incase of any damage, its a bugger because i wanted the chassis rolling this long weekend