Yeah. I had to drill 2 new inboard holes on each side to fit the seats when I replaced the bench, then used nuts with large flat washers. I may weld some nuts in if I get a chance when it's on a hoist, but it's fine the way it is.

And I don't think my original sill trims are stainless, they appear to be that silver/grey zinc plating. The chrome ones I used are from a HQ Premier that I bought years ago for my ute and never used. The holes were in a different place on them too!

We took it to the local show and shine today and it got a lot of favourable comments. I even got a few votes in the entrants choice category!

It's nice that other people like what you've done, (especially people on this forum that seem to have good taste) even though I do what I like not what other people want me too. My van.... My way.