Next Project Factory HQ 308 XX7

**steve1975** · 16-06-2014, 05:46 PM

Keep up the hard work. The yellow is an awesome colour, keep going the pain will end soon.

**Duc1991** · 16-06-2014, 06:36 PM

Great work. Looks to be a long slow job. Looks like you used wire wheels and paint stripper. What treatment are you going to give the bare metal? Are you going to put any type of rust converter?

**hqhzvans** · 16-06-2014, 06:55 PM

Originally Posted by Duc1991

Great work. Looks to be a long slow job. Looks like you used wire wheels and paint stripper. What treatment are you going to give the bare metal? Are you going to put any type of rust converter?

Yeah paint stripper a couple of times , coarse steel wool wire wheels, nylon pads etc trying everything I can think of , yeah not sure exactly about the next stage was reading up about the Rust Bullet which one of the guys I think Taily ? has given glowing reports about, going to get my Panelbeater over to have a look and pick his brain

**Duc1991** · 16-06-2014, 07:45 PM

Originally Posted by hqhzvans

Yeah paint stripper a couple of times , course steel wool wire wheels, nylon pads etc trying everything I can think off , yeah not sure exactly about the next stage was reading up about the Rust Bullet which one of the guys I think Taily ? has given glowing reports about, going to get my Panelbeater over to have a look and pick his brain

You're doing a great job. I put an old foam mattress in the back of my HZ so I could sit, lie and roll around while sanding as I have a knee replacement and can't lean on it for too long.