Steering columns explained

[stickthis]

if i have one in a column with a key then i will be glad to extract money from you with a small donation going to the government...

haha cheers mate that would be very kind of you. Im 99% sure I dont have any. I have a box full of them somewhere so will have to have a look.....

[mr.jones]

Great thread Greg , could you post a pic of the HX and HZ coffee pots together showing the different angles for ignition barrels.

Thanks for the pic of the ignition rods, I have put an HZ column in my HQ and couldn't remember which one I needed its been so long since I pulled them apart. :o

Leroy

[ozbox]

Great thread Greg , could you post a pic of the HX and HZ coffee pots together showing the different angles for ignition barrels.

Thanks for the pic of the ignition rods, I have put an HZ column in my HQ and couldn't remember which one I needed its been so long since I pulled them apart. :o

Leroy

thanks leroy...yes i shall do that for you during the week..:Hair:

[Blocker]

I'm having trouble removing my steering wheel from the column.

Horn cap off.
Removed centre nut and surrounding nuts inside steering wheel.

Do I need to remove the ignition barrel and shroud as well? Because my service manuals don't mention that and I have been trying to lift/pull the steering wheel off with no luck so far.

[ambientgoat]

You'll be wanting a steering wheel puller. They screw onto the boss and then a larger screw pushes down on the shaft freeing the wheel.

If you get stuck, I have one in the shed.. I think.. somewhere.

[ozbox]

You'll be wanting a steering wheel puller. They screw onto the boss and then a larger screw pushes down on the shaft freeing the wheel.

If you get stuck, I have one in the shed.. I think.. somewhere.

yes its a good investment..go buy a puller set...

--- Updated ---

I'm having trouble removing my steering wheel from the column.

Horn cap off.
Removed centre nut and surrounding nuts inside steering wheel.

Do I need to remove the ignition barrel and shroud as well? Because my service manuals don't mention that and I have been trying to lift/pull the steering wheel off with no luck so far.

you cant remove any of that stuff without first removing the steering device..

--- Updated ---

then once you have the steering device off you will need this thread ..
http://www.mysandman.com.au/forums/s...el-..explained

[Blocker]

You'll be wanting a steering wheel puller. They screw onto the boss and then a larger screw pushes down on the shaft freeing the wheel.

If you get stuck, I have one in the shed.. I think.. somewhere.

I'll take you up on that offer, as well as the engine crane. Do it all in one hit, I have two steering wheels to remove, one is a 5mm the other a 3mm. One of them will go on FleBay.

Thanks.