Gday Damien,

In my book it lists as follows,

1st Plug.

Violet = ECU terminal C14 to Oxygen sensor.
Violet = There is also a violet power feed from fuel pump relay to electric fuel pump. Also linked to oil pressure switch.

Red = ECM terminal D7 main feed wire to injectors, ignition coil, oil pressure relay, ignition module. (This should be a larger red wire to handle higher amperage).
Red = ECM terminal B8 to A/T control circuit. ( this would be a small red wire).

Pink/blue (KL) I don't have this wire listed.

red/black = goes from terminal C11 at the computer (ECM), to diagnostic plug terminal 9 the linked to body control wiring BCM.
There is also a red/black running from battery to 25amp fuse to terminal D1 at the ECM, and linked
to the EFI relay.

Green/white = terminal A1 at ECU goes to fuel pump relay.
Green/white = There is also a Green/white running from terminal A11 at ECM to A/T control circuit.

2nd Plug,

Brown = ECM terminal D9 to manifold air temp sensor (MAT sensor). Is also linked to MAP sensor.
Brown = There is also a brown wire at ECM terminal B12 to climate control module. This wire is most likely a trigger to bump up the idle when the A/C cuts in.
Brown = There is also a brown wire from the ignition module to coil, also feeds tacko and tacko signal.

Green = There isn't a single green wire listed in my wiring diagram it may not be related to EFI wiring. or a secondary sub connection.
Light green = ECM terminal C10 to MAP sensor.

Blue = ECM terminal C5 to throttle position sensor.
Blue = There is also a blue wire from ECM terminal B1 to power/economy switch.


Can't find a green/black but there is a light green/black.
Light green/black = ECM terminal C8 to idle air control motor.

Blue/white = ECM terminal B5 to speed sensor.

DSC_0052_4[2654].JPG


If you expand the attached photo you should be able to read it to help identify some wires.
Hope this helps.

Lenny.