sandman identification hj ute

[playwme]

when you check with customer assist would they have details? or would they say kingswood ute 308

Ha! About the best they'll do is tell you that it's not a Toyota or a Ford.

[Taily]

hi guys , i have the chassis number
it goes like this BHJ10585M

see what you think....neil

Geeze they must have been absolutely punching them out back then. My ute was built a mere 7 months prior and its chassis number is [same letters]04700M!

Just think, if we (as a nation) were all still buying Australian and the car manufacturers were punching those numbers out still there would be no talk of closing.

Very nice ute by the way...

[seavan]

Im no expert but I noticed the mount missing also. I think the dash is out of a later model by the rts badge and has statesman doors on it. Not picking on it but its a bitsa underneath it all but you never know!

[neilwise]

yes front bracket missing,they have fitted non gen seats,red oxide primed floor, i can see marks where it should be. i think the dash has been changed also, incorrect colour,woodgrain facia, tags never removed,Jamaican lime every where ,also has been red & white as well..the guy said a farmer had it from new, then his sons played with it as a hack on the farm,,

[HK1837]

Being an auto you need to look for factory console and factory T-bar evidence. As I said with an auto it will have the rear floor mount in either case.

Seat mounts are irrelevant. You could go looking for blackouts. Just look for what I said previously re strips.

[HK1837]

They'll be able to tell you it is a HJ Kingswood with L31 M41 driveline and the date it was completed. That is assuming they get it right which they do maybe 50% of the time. They no longer know how to read their own historical information hence one of the reasons why they make so many mistakes.

[Robbo]

Very nice combination indeed. Even if it isn't a sandy it is still a very remarkable and uncommon vehicle, would be very few ute's around with that build.

Cheers.

[pj350]

Did see that ad... that paint motor trans combo great one. .....Your just going to have to do some sanding and poking around to see any past evidence of black outs console mounts , protector strips etc.......if it is looks like most the bits have been taken off at some stage.

[neilwise]

hi guys, removed inside tray mounts, no signs of trim holes, i think i will sand down extra layers of paint to look for stripes & black outs.
hard business this.lol. its as bad as identifying a real xu1 ... consule mounts looks to have been cut off, hole in floor looks original.also has hole above it for wiring
they have stuck stupid seats in it as well....lucky i have all that , i think last counti had 10 gts steering wheels on the hook, looks like quiet a few are sandman,

neil

[HK1837]

HJ Sandman wheel is the same as many others, nothing special about them. Just a blank cap.

Shouldn't have a hole in the floor for wiring for an auto car, only 4spd has this. Trim holes in teh quarters are right at the back. Only one per side.