HZ front spoiler

[Valencia]

So are they factory cut outs as my front apron hasnt got them but its not from the original body

[Indy Orange]

No, mine are not factory cut outs.That green pic of the front cut out IS factory, from a Sandman ,courtesy of a forum member I took stencils of these and transferred them to mine and did the cut outs,the front and rear spoilers were an option on GTS Monaro except HZGTS,not sure about Sandman?in my experience I have rarely seen the factory cut outs on GTS or Sandman ,maybe front ends get changed over the years.

[Cocko750]

Front spoiler is plastic have one in Holden bags got from a swap meet but I don't have the holes in a front to measure , also did Hx have the chin spoiler or not, they didn't have Gts guards or quad front ?

[Indy Orange]

DSC_0966_zpsa37440e4.jpgDSC_0967_zps5542c26b.jpgFrom a thread on here a while ago .

[wbute]

No spoiler on HX Sandman.

[Cocko750]

No spoiler on HX Sandman.

Thanks wb thought not ,they were lacking in cool bits compared to early and late wonder why ?was Holden winding down the sandman? I know a mate had a Hx Kingswood ute 308 4sp all the bits and stato front , he thinks original owner had the front fitted after a roo hit but deville blue Gts dash , he was a farmer so maybe he needed a work ute but couldn't get the stripes of a sandy so optioned up a Kingswood . I know the old man had to buy a ute that suited his old man( a farmer) as it had to be used for the farm duties.

- - - Updated - - -

Thanks Indy new I had seen it here somewhere

[jennie285]

We bought two rares spoilers for our yellow and red van. With a bit of a grind Rodney made them fit and they look fine

[Indy Orange]

We bought two rares spoilers for our yellow and red van. With a bit of a grind Rodney made them fit and they look fine

Glad the Rares ones turned out for you Jennie,i had a real battle getting a good one to fit ordering a front and rear for a GTS on ebay from country VIC which turned out to be absolute rubbish,so bad in fact that they just couldn't be fitted,the rear was the worst, too short for the boot lid ,after I made the complaint the listing suggested '' may need finishing off to fit",seriously just junk ,ended up in the bin.Later speaking with two car club members about this I found out they had also been stung.So I contacted Ernicks Wilson fibreglass who sent me a quality finished item.I should have gone there first.

[Valencia]

So do you have to cut the holes in the front apron to install the spoiler

[Indy Orange]

The air intakes sit inside the cut out sections normally on the front lower panel if you don't have the cut outs it wont sit right unless you grind the air intakes down a bit from the inside of the spoiler,err hope that makes sense.