Chevrolet Motor Swap

[HK1837]

Maybe PM Greg Barker through this site first to see if they can freight to the USA. When you say 383 Chev too, the mounts I put up are for a 1958 onwards Small Block Chev (2 piece rear main seal Chev engine). I think they also suit the GM LT (GenII) engine with one piece rear main seal, just check they are the same mount casting on the sides.

You may be able to buy headers, a speedo cable and gearbox crossmember over here for it too ready to use.

Headers are everywhere for this conversion, just look on Ebay for Small block Chev in HQ-WB.

Speedo cable, these guys or Mal Wood in QLD will make one: http://www.rodshop.com.au/index.php/...edo-cable.html

CRS again for gearbox crossmember: http://www.rodshop.com.au/index.php/...s-members.html