HJ Panelvan pivot point

[seavan]

I recently finished one for my van and will get the measurements for you tomorrow. I used the rear bumperettes and the chassis points under the fire wall. From memory the front was 350mm up from the chassis points and the rear 450 up from the bumpettes but will get them exactly tomorrow. Took a bit of messing around to find them but in the end it turns really easily. Very time consuming until you get them right though!

[Sparks]

Hi seavan, how did u go getting the pivot points for ur sandman body, I too would be very greatful with measurements as I need to put mine on a rotisserie as well, head to get this right first time if possible.
My thx Sparks

[Sparks]

.

I recently finished one for my van and will get the measurements for you tomorrow. I used the rear bumperettes and the chassis points under the fire wall. From memory the front was 350mm up from the chassis points and the rear 450 up from the bumpettes but will get them exactly tomorrow. Took a bit of messing around to find them but in the end it turns really easily. Very time consuming until you get them right though!

Hi seavan, how did u go with the measurements for body to go on a rotisserie, I'm at that stage as well