restoring

**doggindan1** · 01-09-2011, 07:23 PM

didnt find any papper work under the passanger seat so the only thing left in the panelvan is the dash so my finger a crossed something will be there but my hopes ant that high coz noting was found under the seats or carpet

**doggindan1** · 03-09-2011, 01:30 PM

g'day all i have had a look at getting the gts dash out but cant see how to get it out any help would be much apreciated as i have never done this befor
thanks
Dan

**wbute** · 03-09-2011, 06:37 PM

Pull glove box out(screws through b pillar and inside glove box). Pull lower dash facia off(scews in b pillar and you will find the others).Undo screws in near the tacho/speedo/steering column. Undo all the other screws in the facia that I cant remember.
Remove facia being careful not to snap it as it clears the column(I think the steering wheel has to come off too). You have to diconect the clock wiring first and then it should come out.
I havnt done this job since the week before AHD last year so I could have missed a couple of things.

**adam perth** · 03-09-2011, 06:40 PM

don't forget the screw behind the ash tray, if you forget, it will snap and its all over.

**doggindan1** · 03-09-2011, 08:03 PM

thanks i'll give it a go

**doggindan1** · 04-09-2011, 06:46 PM

ok after pulling the drivers side door off today there is a lot off rust in her.:( i'm thinking i'm in need of a front end from a hx panelvan to be welded to the back half
i'm not shore i've never done anything like this befor so any help would be great
i will try and get some photos up soon witch i hope will help show you what i am seeing
thanks
Dan