restoring

[doggindan1]

lookin at your floors and the right pillar i would think that she will be pg13ed in the chambers as well..quickest fix for that is a front cut..you can use a front cut from any car or wagon or ute or van..all the same within small bits hjxz...panelbeater job but..but in saying that its not a hard job for an old school beater and shouldnt be too expensive as stripped vehicles..1k to 2 k plus a front cut which should be able to be found for around $495..you want to see any front cut bare before you buy it tho as you could end up with the same probs..what area you in?

in melbourne altona
i have no idea what i am doing so any help would be great even if it means getting the car cut and ready to be welded for someone how knows what there doing
i would think it would be easyer to just get a hole front end of another panelvan and weld it onto mine but i have no idea of what it would cost to do a job like that
then i also have to do both side sils there is a fare bit of rust in her so if i could get it cut out for a panelbeater or someone of the like to do it i hope it would cut the cost down
any help would be much apreceated as this is my first go at fixing up a car