Back from the soda blaster

[sstevo05]

That gutter rust is the same as mine - glad to hear that you guys think its not too bad

[jennie285]

Today we pulled out the motor, which we have sold to a guy for his boat, kept the carby which is a Rochester, and a major issue with the nosecone which our panel beater says will take some too much time to repair, but can be done if we don't' find another one. Also the guard is badly dented on the passenger side, but we have a doner HZ we could get one from, and a rear quarter panel we found had been badly repaired in its last repaint, still working on that, but we have the technology









The doors are all done and undercoated with the first undercoat



And the bonnet has been panel beaten and undercoated

[jennie285]

Cut out the old beaver which had been smashed in like hard, and hidden by the stato bumper, and new one cut out of from the wreckers





the doner HZ ute (oz's)

[jennie285]

Tidy up some dents on the edges around the beaver panel



Cut rust out of left hand rear quarter and weld plate in on the inside and outside



Weld in floor stiffner, and spare tyre chassis winch framing, which was taken from oz's HJ ute, before we knew it was going to be his. :errf:

[ozbox]

thats ok jennie...i dont need that bit...:Chin:

[Blocker]

I did :cry:

[stickthis]

I did :cry:

I have a WB ute with it if your keen Blocker.