how wide can i go?

[Maysik]

thats basically what i am after i also had 10'' hotwires on the rear of a wb ute but still had to modify the lip. but i need to know how much backspace i have on the hz van before i start looking at combinations.

Lot of factors to consider when copying someone else's set up. I will find it difficult because I have a non standard diff, it's a disc brake rear from a Statesman that puts the hubs outboard 9mm.

Perhaps you might have to bite the bullet and take the wheel off and measure offsets and centres etc and go to a fitment guide. That way it will be dead accurate for your vehicle. Most wheel websites have them, I know Dragway has a good one.
Hope this helps.

[Big Rob]

Yep. And the profile and width of the tyre.

[jason.ruff]

Drill a hole it a bit of flat bar and bolt it onto a wheel stud. This will give you a measurement from the wheel boss to chassis or other obstruction and to front lip of quarter panel. Best way I've found to get maximum width and correct offset.

[Maysik]

Drill a hole it a bit of flat bar and bolt it onto a wheel stud. This will give you a measurement from the wheel boss to chassis or other obstruction and to front lip of quarter panel. Best way I've found to get maximum width and correct offset.

Good idea, I'll be using this when I measure up. Thanks.

[flamenco]

that sounds like the go jason ill see what i come up with. cheers

[Vombil]

sorry to hijack

can someone tell me if 18x8's and 18x9's will fit onto a Q 1 tonner?
also what sorta tyre width would i need (minimum) to cover all those inches. thanks

showwheels 'SW-1 i think they are called streeta.

18x8's say hub is 73.1 offset - 0

18x9's say hub is 78.5 offset - 6

[agr071]

My 235/60R15 tyres would scrub continually if I lowered it.
All because of the offset of my Strikers.