WTB 10 bolt salisbury diff gears 3.36 or 3.55

[hogvan]

Hi all, hope someone can help me, i've just pulled my diff apart to run a trutrac centre and 31 spline axles and have discovered I have a ratio of 2.78, i'm chasing either 3.36 or 3.55, 3.08 as a last resort. Has anyone got a set lying around I need some asap, thanks James

[agr071]

IF you decide to sell the 2.78, let me know as I may be interested.
(Would have to freight of course so it'd be depending on cost of both)

[hxbunny]

I think the diff housing is different for 2.78, could be an old wives tale but someone did tell me a while ago.

[XX7SANDMN]

different housings due to bigger carrier bearings and are the same as 2.60

[hogvan]

Shim it out plus I am running a eaton hemisphere, it will fit, agr071 i'll let you know about the 2.78 it's nice and quiet in my van.

[Beachy]

Are you sure there is difference I thought they were all the same ,not sure about 2.60

[Valencia]

different housings due to bigger carrier bearings and are the same as 2.60

I thought that was only banjos not salsburys

[agr071]

Shim it out plus I am running a eaton hemisphere, it will fit, agr071 i'll let you know about the 2.78 it's nice and quiet in my van.

No worries. Thanks

[ZSANDY]

I might have some gears spare for sale . If your still chasing some I could check and let you know. As for lower gears fitting in a 2.78 housing i don't think they fit . I did a swap years ago and I think I even had to shorten an axle after moving the carrier across. Alright for a temporary fix but not a thing you'd want long term.

[hogvan]

Thanks, ZSANDY I got some gears 3.08 they fit in the housing fine