HQ-HJ,X,Z Dash conversion.

[sandman350]

yeh when i read adams comment i had to go look myself coz i could not remember doing one???
i did one years ago and ive seen some pretty bad ones over the years..best way to do the conversion is to unpick it back to the bulkhead/firewall and do the same with a hjxz one and then weld it back in again..fairly simple but time consuming...

Probably a good way to go, i need to replace the HQ cowl panels with HJ-Z ones anyway. Might wait till i get my new shed i think.....

[ozbox]

Probably a good way to go, i need to replace the HQ cowl panels with HJ-Z ones anyway. Might wait till i get my new shed i think.....

that is the easiest way as the cowl section from the factory starts at the firewall,forward of compliance plates.and finishes where you attach the dash pad to...