Damo there isn't much to configure or wire in. 12v fused battery ECM supply, 12v ignition switched, A/C request to better control your idle, and the standard plug ins for the EFI and fuel pump relays which would still be on your harness. I got Calmaker to burn me a new Memcal. My V8 engine, harness and ECU was from a 1993 VR HSV Clubsport with 4L60E. He switched off the auto and configured it for a manual. The HSVs have a knock sensor so he also set the tune from 185kw to 195kw. I also got him to remove the VATS but in hind side I should have just used a voltage reducer/regulator (12v to 5v output). The ECM needs a 5v signal from the BCM for the ECM to wake up. It will save you heaps of time trying to fit the BCM and key reader to do the job. I could have used the alarm to switch on the voltage regulator or used a hidden switch to further protect the car from theft.

I also got Calmaker to set a thermos fan cut in to 93 deg C. The V8 engines didn't have thermos fans from factory only the V6 and both had A/C condenser fan. I don't remember if Holden configured the fan ECM output from factory or if Calmaker switched it on. I have never used the fan override but its peace of mind knowing its there. I don't have a condenser fan but triggered the two thermos fans to cut in when the compressor clutch cuts in regardless of engine temp.