So the project has been a bit slow over Christmas and New Year, but after checking out Grunts wagon, i got some mojo on in the last week or so and had the brake line man down to finish all the brakes, fuel system and trans lines. Didn't quite work out so well on the day and another visit is needed to finish things off. Turns out that the CRS Wilwood master cylinder and proportioning valve kit doesn't have a brake fail switch in it, so i've got to swap out the valve for a different Wilwood proportioning valve that does have the fail switch. Lessons learnt!
So i've pulled finger and jumped on the wiring this weekend. Its very daunting to look inside the plastic storage tub and see a WB SII Caprice loom and know that it all has to go back in (well into a van for the first time) and also get modified for neatness and custom options etc. This is where the tonner tray comes into its own, its just a great workbench for spreading out wiring looms, then deciphering them and cleaning them up. I decided to cut the loom in two places and make new plug and play connectors at each cut. I cut the front engine bay section off which pops out the firewall near the steering column and also cut the rear section off at the drivers side kick panel, so i've now got three loom sections. I've decided to have three main loom holes for the front end, with one in each A pillar and one behind the engine/gearbox. I think i can pick up everything electrical in the front via these three holes. I also decided to pop a hole in the spare fresh air vent plate on the drivers side and use this to feed the washer fluid tube, wiper motor and brake switch wires into the plenum area to keep them hidden.
Got it all fairly clean and sorted out by lunch yesterday and threaded the main section into the van by early evening. Surprisingly, the WB van seemed to be set up the same as stato for the loom and had all the mounting points and option locations, so it went really well.
Spent today figuring and cutting out new hidden loom holes in the pillars and mounting up computers and speedo conversion box.
As usual, some pics below;
20190112_112211.jpg
20190112_152412.jpg
20190112_152444.jpg
20190112_152544.jpg
20190112_152641.jpg
20190112_165621.jpg
20190112_195848.jpg
20190113_121406.jpg
20190113_121512.jpg
20190113_123447.jpg
20190113_123522.jpg
20190113_124337.jpg
- - - Updated - - -
Quick addition here as i wanted to ask for feedback. For anyone who has installed a 304 EFI into their van (or other HQ-WB ride), is the passenger kick panel area a good spot to mount the Delco computer? Pics below, feedback appreciated. Cheers
20190113_162159.jpg
20190113_162224.jpg
20190113_162327.jpg





Reply With Quote
Bookmarks