The steel ring used on the steering wheel has been shaped. It is not just a piece of round. This ensures the moulding adheres to it and cannot be twisted. It is not just rubber. You would have difficulty removing the polyurethane as any remaining could be effected by heat generated in welding. Then a correct adhesive would have to be used to make the end finish acceptable. The integrity of the weld is the next concern. The Rare Spares wheels go through a very comprehensive test to conform to ADR10. A rebuilt wheel should have to do the same, as fitting a wheel that is non compliant may void your insurance if it was in an accident and found to be at fault.