Results 1 to 10 of 10

Thread: no power to cranking wire at starter - WB V8 autp

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Super Moderator Taily's Avatar
    Join Date
    Oct 2011
    Location
    NW Sydney
    Posts
    1,185
    Stretching the memory a bit here but think the inhibitor switch wiring is (purple - I think?) at the switch (either on the t-bar or at the base of the column if it is a column auto. Either way, if you can pop the harness off the switch and with a test light see if one of the wires is energised when you turn the key to 'crank'. If it is then the ignition switch isn't the issue. To then check the inhibitor switch (only if you think it is dicky or you could just skip this step and go back and check it later if you still have an issue) you can either bridge the two wires (be careful as if it is going to start it will start in gear with thess wires bridged), and then using a test light down at the starter solenoid wire see if you have power while cranking.

    If you have power to the solenoid while the key is in the 'crank' position then the issue is within the solenoid (as you've already tested that by bridging it).
    Nunc est bibendum...

  2. #2
    Night Rider Vombil's Avatar
    Join Date
    Feb 2011
    Location
    Western Suburbs
    Posts
    2,630
    Quote Originally Posted by Taily View Post
    Stretching the memory a bit here but think the inhibitor switch wiring is (purple - I think?) at the switch (either on the t-bar or at the base of the column if it is a column auto. Either way, if you can pop the harness off the switch and with a test light see if one of the wires is energised when you turn the key to 'crank'. If it is then the ignition switch isn't the issue. To then check the inhibitor switch (only if you think it is dicky or you could just skip this step and go back and check it later if you still have an issue) you can either bridge the two wires (be careful as if it is going to start it will start in gear with thess wires bridged), and then using a test light down at the starter solenoid wire see if you have power while cranking.

    If you have power to the solenoid while the key is in the 'crank' position then the issue is within the solenoid (as you've already tested that by bridging it).
    cheers Taily

    I just had my bro hold the key to crank. One good WB was over 12V the dud one was 0.12V when cranking! So it's getting some power but yeah. it aint ever going to start. wiring?? can it be a switch if some power is getting through? thanks
    BQZ

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •