hq van hood lining

[AN5590]

Not sure if this will help much but have attached a diagram from the HQ Service Manual re: Panel Van Headlining. Cheers

HQ_PV_Headlinining.PNG

[axistr]

If your windscreen is already out I would fit the lining first, its just easier to get it sitting good without to many wrinkles. As said previously I also used a dozen cut up pieces of old pinch weld and keep pulling and tucking the lining into place. It's been a while but from memory mine had two bows in the front section (WB) mine had six including the rear. I had a couple of wrinkles when I had finished, just have it a light wave over with the heat gun and come up perfect.


DSC_0102.JPG

DSC_0106.JPG

[HQ Freek]

Thanks guys.
Both the diagram and photo show only the one seam or bow in the front.
Guess I’ll just get the front one off Jason and see how I go.