Drill a hole it a bit of flat bar and bolt it onto a wheel stud. This will give you a measurement from the wheel boss to chassis or other obstruction and to front lip of quarter panel. Best way I've found to get maximum width and correct offset.
Drill a hole it a bit of flat bar and bolt it onto a wheel stud. This will give you a measurement from the wheel boss to chassis or other obstruction and to front lip of quarter panel. Best way I've found to get maximum width and correct offset.
Good idea, I'll be using this when I measure up. Thanks.Originally Posted by jason.ruff
that sounds like the go jason ill see what i come up with. cheers
sorry to hijack
can someone tell me if 18x8's and 18x9's will fit onto a Q 1 tonner?
also what sorta tyre width would i need (minimum) to cover all those inches. thanks
showwheels 'SW-1 i think they are called streeta.
18x8's say hub is 73.1 offset - 0
18x9's say hub is 78.5 offset - 6
Last edited by Vombil; 01-05-2016 at 11:46 PM.
BQZ
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks