Tail Gate Hinges

[tidyvan]

I like what you've done with your hinges and plan to do the same to mine. Was it hard?

[HZSM50]

I like what you've done with your hinges and plan to do the same to mine. Was it hard?

No not at all. After getting to old pin out just measure to the centre of the new pin I drilled a 1/8 hole to a dept of half and then though the centre of the new pin to the middle so the two hole came together then tapped a thread the same as the grease nipple and all done. And don't fogey to weld the new pin in.