Slowly making a start on my new hz xx7 project

**rathyhg** · 01-05-2016, 05:15 PM

It's a 6205 std roller, I took a lil out of the ID and it's a tight fit on the shaft. And I just skimmed a bit off the old plastic part to get it sitting neat.... That sound confusing but u will understand when you do it yourself.
I might start rebuilding a few. After seeing the price of them on evilbay

**Valencia** · 01-05-2016, 06:21 PM

[QUOTE=rathyhg;103643]It's a 6205 std roller, I took a lil out of the ID and it's a tight fit on the shaft. And I just skimmed a bit off the old plastic part to get it sitting neat.... That sound confusing but u will understand when you do it yourself.
I might start rebuilding a few. After seeing the price of them on evilbay[/QUOTE
Where would get one of those bearings from

**Cocko750** · 01-05-2016, 06:42 PM

6205 is a standard bearing from any bearing centre or parts place should have them or get one

**Valencia** · 01-05-2016, 09:02 PM

Originally Posted by Cocko750

6205 is a standard bearing from any bearing centre or parts place should have them or get one

Thankyou

**Cocko750** · 01-05-2016, 06:48 PM

Originally Posted by rathyhg

It's a 6205 std roller, I took a lil out of the ID and it's a tight fit on the shaft. And I just skimmed a bit off the old plastic part to get it sitting neat.... That sound confusing but u will understand when you do it yourself.
I might start rebuilding a few. After seeing the price of them on evilbay

Thanks mate will check A few of my columns to see which need doing and try it out should have one of the bearings sitting in the cupboard and a new top bearing in toolbox, make up a reco column like you have it looks good