The frame where the windscreen sits must be cleaned of all sealer residue and the primer applied to the area. Also prime the edge of the windscreen.

place two of the rubber blocks one above the other on each side of the bottom Chanel. These act as spacers and are left in place with the fitted screen... Otherwise on a hot day the screen could slip down causing it to leak at the top.

starting in a bottom corner apply the tape to the frame and expose the wire at each end once you have laid it around the frame.

you will need two 12v batteries joined in parallel to creat 24 volts and attach positive to one end of the wire and negative to the other end.

once the butyl has softened sufficiently lay the primed windscreen onto it and apply even pressure around the edge of the screen ensuring you have full adhesion.

Disconnect the battery and allow butyl to cool.

fit windscreen trim.

This system works very well if installed properly.