Would have to be one of the best HZ Sandmans available. Is genuine in all aspects.

**hxbunny** · 15-12-2010, 07:53 PM

Don't the sill moulds clip onto tabs that are fixed to the sill panel, would be fairly difficult to fit after the factory, whereas the wheel arch trims are only screwed on.

**HK1837** · 15-12-2010, 09:24 PM

Originally Posted by hxbunny

Don't the sill moulds clip onto tabs that are fixed to the sill panel, would be fairly difficult to fit after the factory, whereas the wheel arch trims are only screwed on.

GMH supplied special screws for the purpose, they looked like a stud but had a phillips head. They were used for all the locations where studs were needed, eg if a new sill was fitted it wouldn't have the studs on it, same for quarters, door skins, guards etc.

**hxbunny** · 17-12-2010, 12:46 PM

Originally Posted by HK1837

GMH supplied special screws for the purpose, they looked like a stud but had a phillips head. They were used for all the locations where studs were needed, eg if a new sill was fitted it wouldn't have the studs on it, same for quarters, door skins, guards etc.

Ok thanks for that, learnt something today. Where there any from the factory that look like the ones that hold the clips for the windscreen trim ?

**HK1837** · 17-12-2010, 01:44 PM

Originally Posted by hxbunny

Ok thanks for that, learnt something today. Where there any from the factory that look like the ones that hold the clips for the windscreen trim ?

Yes, same thing. I wouldn't use them on the lower section though, you are better off getting a beater to spot weld some easy-beat (or whatever they are called) tabs on there for you.